DLP is unable to perform detection when copying a renamed folder to an MTP device

Products

• Data Loss Prevention Endpoint Prevent

Issue/Introduction

When copying a folder to an MTP device the detection occurs, however, if we rename the same folder and try to copy it again to an MTP device the detection does not occur.

Steps to repro: 

1. Create a folder and copy a sensitive file to this folder

2. Copy the folder created in Step 1 to an MTP device

3. We will get a block pop-up

4. Rename the folder and drag and drop the folder to the MTP device again and the detection fails. 

 

Environment

Release: 16.0

DLP is unable to perform detection when copying a renamed folder to an MTP device

Cause

This is a defect in DLP 16.0

Resolution

Resolved in DLP 16.0 RU1 and 16.1