show -i CLI command not showing exact status of S550 appliance PSU

Products

• Endpoint Detection and Response Hardware

Issue/Introduction

After running the show -i command on Endpoint Detection and Response (EDR) CLI, the Power Supply Unit status shows as below.

Power Supply:

    System Power Supply
        Power Unit Group: 1
        Location: To Be Filled By O.E.M.
        Name: To Be Filled By O.E.M.
        Manufacturer: To Be Filled By O.E.M.
        Serial Number: To Be Filled By O.E.M.
        Asset Tag: To Be Filled By O.E.M.
        Model Part Number: To Be Filled By O.E.M.
        Revision: To Be Filled By O.E.M.
        Max Power Capacity: Unknown
        Status: Present, OK
        Type: Switching
        Input Voltage Range Switching: Auto-switch
        Plugged: Yes
        Hot Replaceable: No

Environment

Endpoint Detection and Response and  EDR appliance S550

Cause

EDR currently uses the 'dmidecode' command type to provide the Hardware information. 'dmidecode' command will only provides what the motherboard on the appliance ( S550 here ) can detect from CPU

Resolution

Currently as per the design EDR is not able to show the status of individual power supplies.