Encore step failed with CYBRM000 not APF-AUTHORIZED on ESP Workload Automation

Products

• ESP Workload Automation

Issue/Introduction

After an IPL, JOBs failed with the following message although ESP LOADLIB is APF-Authorized:

ESP ENCORE CANNOT CONTINUE PROCESSING BECAUSE         
IT IS NOT APF-AUTHORIZED.                             
                                                      
THE LOAD MODULE NAMED CYBRM000 IN THE ESP LOAD        
LIBRARY MUST HAVE AN AUTHORIZATION CODE OF 1.         
THIS VALUE IS SHOWN IN THE ISPF MEMBER LIST           
IN THE COLUMN HEADED BY 'AC'.                         
                                                      
IN ADDITION, IF ESP ENCORE IS EXECUTING FROM          
A STEPLIB LIBRARY, THEN THAT LIBRARY MUST BE          
APF-AUTHORIZED.  TO BE AUTHORIZED, A LIBRARY          
MUST BE NAMED IN THE APF LIST, WHICH IS A             
MEMBER OF SYS1.PARMLIB WHOSE NAME BEGINS WITH         
'IEAAPF'.  THE FULL MEMBER NAME IS USUALLY            
'IEAAPF00', BUT MAY BE DIFFERENT ON YOUR              
SYSTEM.                                               

Environment

Release : 12.0
Component: Restart Option(Encore)

Resolution

The module CYBRM000 may reside on other libraries (than the one that's APF-Authorized).

Check the PROC specified on ERMSTEP in ESPPARM.