- Name: The name of your new Software Instance. You will identify your SMP/E Environment by this name in z/OSMF.
Click NEXT - System: The system where your CSI resides.
- Global Zone CSI: The data set name of your CSI. It must end with “.CSI”.
Click Next - Target zones: Select all target zones which are present in your CSI.
Click NEXT to progress through the rest of the selections until you get to the last page and then click FINISH
After the wizard is finished successfully, you should see your new Software Instance in the table of all Software Instances.
Register your SMP/E Environment (CSI) into z/OSMF
Article ID: 262708
Updated On:
Products
Datacom
Datacom/DB
IDMS
IDMS - Database
Issue/Introduction
Register your SMP/E environments (CSIs) in z/OSMF so you can apply maintenance.
Resolution
Steps:
1. Login to z/OSMF
2. Select Software Management, Software Instance
3. Click Actions, then click ADD
4. Then follow the wizard to register new Software Instance which represents your CSI.
You would need to provide the following information:
Additional Information
Feedback
Yes
No
Powered by
