MUX - Parameterised Lookups are not clearing off after PROD Upgrade to 16.1.0.1

Products

• Clarity PPM On Premise

Issue/Introduction

MUX - Parameterised Lookups are not clearing off after PROD Upgrade to 16.1.0.1

Steps to Reproduce: 

1. Configure Idea blueprint with Idea Type and Idea Category attributes.
2. Navigate to Ideas and ensure your idea is linked to the modified blueprint from step 1.
3. Open an idea and set Idea Type and Idea Category.
4. Now try to change Idea Type and observe that Idea Category is not getting cleared.

Expected Results: It is expected that dependent lookup should get cleared if parent is changed.

Actual Results: It is not clearing dependent lookupwhen parent was changed.

Environment

Release : 16.1.0

Resolution

DE69048, Resolved in 16.1.1 01 (Pre Patch 1), 16.1.2