Use CA11OPT to check CA11 activity in ESP Workload Automation

Products

• ESP Workload Automation

Issue/Introduction

Check if CA11 is being used and is active in your ESP system.

Environment

Component: ESP Workload Automation
Release : 12.0

Resolution

Check if the CA11OPT parameter is defined in ESPPARM. Then following command can also be issued from ESP page mode:
OPER CA11OPT

The following output shows that CA11 is configured and not active:
Settings for CA-11             
Settings not yet initialized   
CA-11 DBAS Status: INACTIVE    
CA-11 Subsystem:               
CA11OPT <End>                  

The following output shows that CA11 is active:
ESP Settings for CA-11                    
PROCRMS(ESPRMS)  STEPRMS(ESPRMSST)        
CA-11 interface: ENABLED                  
Default restart manager: ESP Encore       
Default initial-run U11RMS step PARM='F'                 
CA-11 DBAS Status: ACTIVE                 
CA-11 Subsystem: CAL7                     
SCHCC internodal notification via GTS     
CA11OPT <End>