Polling delay after SNMPcollector restart
search cancel

Polling delay after SNMPcollector restart

book

Article ID: 261929

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

After restarting the SNMPcollector, the Polling process takes a long time to poll all profiles. This time is higher than the polling interval (5 mins) due to the huge amount of equipment we have.

It can take up to 30 minutes as we have a very large environment. 

Is there any configuration change that can be done to speed up this process? 

Environment

Release : UIM 20.4.x - SNMPcollector any version

Cause

Guidance

Resolution

Development confirmed we do not have a probe configuration setting to speed up the initial polling delay.

Instead, If the number of polled metrics is very high, (millions) it is strongly recommended to increase CPU Resources, and RAM and if possible add additional pollers