GSVX434W warnings in STC after upgrading to SYSVIEW 17.0

Products

• SYSVIEW Performance Management

Issue/Introduction

After upgrading to SYSVIEW 17.0 many GSVX434W messages appear in the STC log.  Such as:

 

GSVX434W (CICSDATA) Member CICSDATA - Diagnostic configuration option VARIABLE-SET is in use.  

 

Value      CICS:=_______:ENABLED                                                                    

 

GSVX449I (CICSDATA) Collection metric CICS = ENABLED                                                     

 

GSVX434W (CICSDATA) Member CICSDATA - Diagnostic configuration option VARIABLE-SET is in use.

 

Value      CICS:=_______:NOTSD                                                                        

 

GSVX449I (CICSDATA) Collection metric CICS = NOTSD                                                       

 

GSVX434W (MQSDATA) Member MQSDATA - Diagnostic configuration option VARIABLE-SET is in use.

 

Value WEBMQ:=:ENABLE 

 

GSVX449I (MQSDATA) Collection metric WEBMQ = ENABLED                                                             

 

GSVX434W (MQSDATA) Member MQSDATA - Diagnostic configuration option VARIABLE-SET is in use.

 

Value WEBMQ:=:NOTSD  

 

GSVX449I (MQSDATA) Collection metric WEBMQ = NOTSD                                                               

 

GSVX434W (MVSDATA) Member MVSDATA - Diagnostic configuration option VARIABLE-SET is in use.

 

Value MVS:=:ENABLE   

 

GSVX449I (MVSDATA) Collection metric MVS = ENABLED                                                               

 

GSVX434W (MVSDATA) Member MVSDATA - Diagnostic configuration option VARIABLE-SET is in use.

 

Value                MVS:JOBALL%_:ENABLE

Environment

Release : 17.0

Cause

The parmlib member MQSVARS contained statements from the previous release.

Resolution

The following changed in the MQSVARS parmlib member in SYSVIEW 17.0:

 

 

VARIABLE-SET      WEBMQ:xxxxx

 

        was changed to 

METRIC-SET         MQ:xxxxx

 

 

Check both the SITE and SYSTEM CNM4BPRM library MQSVARS member for "VARIABLE-SET".   If found, change it to

 

METRIC-SET.

 

Once the syntax is changed, SYSVIEW 17.0 should come up without the GSVX434W messages.  

-

 

 

Note:  The same would be true for any other xxxxVARS members SYSVIEW has.