Got "Insufficient Data" when attempting CSF EC or EJ from ESP Workload Automation system
Article ID: 261379
Updated On: 03-06-2023
Products
ESP Workload Automation
Issue/Introduction
The user reports occasionally error when trying to edit a job's JCL using ESP ISPF user interface (CSF) line command EC or EJ. The error message is "Insufficient data".
Environment
Release : 12.0
Cause
The information related to EC or EJ is stored in the TRAKFILE. If the space in TRAKFILE has been overwritten by newer JOB, then the information is not available any more.
Resolution
Need to increase the TRAKFILE by CYBESUT4 utility.
Feedback
Was this article helpful?
Yes
No
Powered by
