Automation Analyzer batch OPAAMAIN rc=112
search cancel

Automation Analyzer batch OPAAMAIN rc=112

book

Article ID: 261191

calendar_today

Updated On:

Products

OPS/MVS Event Management & Automation

Issue/Introduction

We're building out a new z/OS system and trying to run the Automation Analyzer in batch mode for statistics of message suppression results. The step for the analyzer is receiving a return code 112. 

 

 SDSF OUTPUT DISPLAY JJJJJJJJ JOBnnnnnn  DSID   103 LINE 0       COLUMNS 02- 133   
 COMMAND INPUT ===>                                            SCROLL ===> PAGE   
********************************* TOP OF DATA ************************************
IKJ56644I NO VALID TSO USERID, DEFAULT USER ATTRIBUTES USED                       
OPS0996I Return code from Automation Analyzer module OPAAMAIN is 112              
READY                                                                             
END                                                                               
******************************** BOTTOM OF DATA ********************************** 

Environment

Release : 14.0

Cause

Automation Analyzer batch OPAAMAIN RC=112 is caused by the time field specified in the OPAAISPF input member parameters being inconsistent with the OPSLOG data being analyzed.

Example, time range input field shown in bold:

PARM(OPAABTCH OPST ",                       "* 08:00 * 11:00 ",                                   "* N N Y Y Y Y *)"

Resolution

Correct the time range field to a value consistent with the OPSLOG data being analyzed.

Additional Information

Description of the batch Automation Analyzer input parameters can be found under section 'Where to Find a Batch Job Version of OPSVIEW Option 7.2' in the documentation page referenced below:

Access the Automation Analyzer (Option 7.2)