During CA OPS/MVS startup the OPSMAIN started task can fail with the following informational message: IEF196I IKJ56241I SPECIFIED UNIT IS UNDEFINED. How to resolve this problem?
Article ID: 26118
Updated On:
Products
Issue/Introduction
Question:
During CA OPS/MVS startup the OPSMAIN started task can fail with the following informational message:
IEF196I IKJ56241I SPECIFIED UNIT IS UNDEFINED.
How to resolve this problem?
Answer:
The message indicaties a problem with an esoteric that reference to a unit or volume that is not available.
Use the OPSTART1 startup member to add the following statement right before the OX to the OPSSPAxx member:
OPSPARM Set(vio) value(sysda)
This will allow define the VIO esoteric with your site standard.
Additional Information:
A reference to the OPSPARM command processor can be found in the link below:
CA OPS/MVS - Command and Function Reference - OPSPARM Command Processor
The VIO parameter can be found in the link below:
CA OPS/MVS - Parameter Reference - VIO Parameter
Environment
Component: OPSMVS
Feedback
