Unable to install UIM robot

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

We are getting the following error while installing UIM robot.

Exit Setup
Setup is not complete.  If you quit the setup program now, the components you requested to add/remove will not be installed/uninstalled.
You may run the setup program at a later time to complete the operations.
Are you sure you want to quit the setup?

 

 

Environment

Release : Any

Cause

Inadvertent click on the cancel button or Esc pressed.

Resolution

Note that the "Exit Setup" windows is not an error message.  It indicates that the "Cancel" button was clicked and is asking if you wish to quit the setup.  Simply clicking "No" will allow the installation to continue.