We are configuring SSL for XCOM on port 8045 but we receive a syntax error for the SSL_OPTION configuration when a transfer is initiated. The message is:
Txpi 310: TxpiSSLConfig Syntax error Element nb: 1 Section = <SSL_OPTION> Parameter = <INITIATE_SIDE>
At this moment the current configuration in the configssl.cnf is:
# Mandatory, note that CA-XCOM uses the v3 protocol
[SSL_OPTION]
INITIATE_SIDE = ALL
RECEIVE_SIDE = ALL
# Mandatory
[VERIFY_DEPTH]
INITIATE_SIDE = 4
RECEIVE_SIDE = 4
# Mandatory, note that CA-XCOM uses the v3 protocol
[SSL_METHOD]
INITIATE_SIDE = TLSV1.2
RECEIVE_SIDE = TLSV1.2
XCOM™ Data Transport® for AS/400 i5/OS
The value for the SSL_OPTION section in the configssl.cnf is invalid
The value of "ALL" for the SSL_OPTION section is not valid. The proper value for this instance would be "SSL_OP_ALL". In other words, you would code it as follows:
[SSL_OPTION]
INITIATE_SIDE = SSL_OP_ALL
RECEIVE_SIDE = SSL_OP_ALL