CA-7.012 occurs when command is issued via batch BTI even though command works when logged on to the terminal

Products

• CA 7 Workload Automation

Issue/Introduction

Getting CA-7.012 when issuing a CA 7 command from a batch terminal job (BTI).  Based on security setting for SASSSECI, I have authority to issue to run this and the command  does works when logged on to the terminal.    

BSTR-00  *** INPUT TO BATCH TERMINAL ***                                       
                                                                               
/LOGON ********           * GENERATED LOGON *                                  
  LJOB,JOB=*,LRUNDATE=(23040,23045),LRUNTIME=(0001,2359)                       
/LOGOFF                   * GENERATED LOGOFF *                                 
                                            
                                                                               
CA-7.023 - r12         OPERATOR IS LOGGED ON TO TERMINAL BT2     AT 08:56:56 ON
  23047  085656      LJOB,JOB=*,LRUNDATE=(23040,23045),LRUNTIME=(0001,2359)    
                                                                               
CA-7.012 REQUEST FOR COMMAND ACCESS DENIED BY CA-7.  

Resolution

The batch BTI job requires the input card to start in column 1.  The CA-7.012 is occurring because the input card not starting in column 1.  

/LOGON ********                                           
 LJOB,JOB=*,LRUNDATE=(23040,23045),LRUNTIME=(0001,2359)                  <==this should start in column 1  
/LOGOFF 

Make the correction noted above and run BTI again to issue the command.