WebUI QuickView has job status discrepancy

Products

• CA Workload Automation AE

Issue/Introduction

When viewing a job in the WebUI QuickView tab, there is a discrepancy between the job status displayed in the "Search Results"...

and the status shown for the last run of the job in the "Job Runs" section...

 

Environment

AutoSys WebUI (WCC)

Release : 11.4/12.0/12.1

Resolution

In QuickView, the job status shown in the "Search Results" section reflects the current status of the job. The status for each each job run line in the "Job Runs" section reflects the completion status for that job run. If the job status is manually changed via a sendevent after the last job run, these two statuses will no longer match. When you manually change the status of a job, that is only changing the current status of the job. It does not change the completion status that was recorded for the last run of the job.