e2e_appmon probe getting: HTTP error in StartBrowser statement, code=-400 !

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)
• CA Unified Infrastructure Management On-Premise (Nimsoft / UIM)
• CA Unified Infrastructure Management SaaS (Nimsoft / UIM)

Issue/Introduction

I've created a script in the e2e_appmon probe.  Sometimes the script runs as expected and other times it gives a pop-up error with "HTTP error in StartBrowser statement, code=-400 !"  I've checked the community and found others with the same error, but no resolution.

Environment

• Release: UIM 20.4
• e2e_appmon_dev v2.52

Resolution

1. Start the e2e script by opening a page that doesn't give the HTTP 400 error. 

2. Then navigate to the page you need to monitor.