Issues setting up Fault Tolerant DC

Products

• CA Performance Management - Usage and Administration

Issue/Introduction

I am attempting to setup a new DC to leverage the fault tolerant setup allowed in 22.2, however am unable to assign active/standby to any of the 3 data collectors in operation currently (0 polled items).  

 

 

Configure the Data Collectors for Fault Tolerance (broadcom.com)

Environment

Dx NetOps Performance Management 22.2

Cause

'Capacity' in the data collector list was not populated

Selected:
 Use the data collector as a standby data collector, and populate the Available list in the Data Collector in this Standby Group section with active data collectors ("Active" status) that have the same capacity and that are within the selected IP domain.

Resolution

Fill in the 'capacity' for the DC's in question