ACCEPT CHECK LU04743 cannot resolve Link-Edits
search cancel

ACCEPT CHECK LU04743 cannot resolve Link-Edits

book

Article ID: 256919

calendar_today

Updated On:

Products

XCOM Data Transport - z/OS

Issue/Introduction

We had to re- installed the product due to some problems with the maintenance. LU04743 was applied successfully after the installation. However when we tried the ACCEPT CHECK the following messages were received:


GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMCR32 FOR SYSMOD RO72613. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMISPD FOR SYSMOD RO76173. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMPLTF FOR SYSMOD RO96344. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMZAPI FOR SYSMOD RO96344. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMSEC FOR SYSMOD LU00599. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMCSSL FOR SYSMOD LU01371. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMHINT FOR SYSMOD LU03726. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMHTTP FOR SYSMOD LU03726. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMRCMD FOR SYSMOD LU03726. DEFAULTS WERE USED.
GIM24701W    SMP/E COULD NOT OBTAIN LINK-EDIT PARAMETERS FOR LOAD MODULE XCOMLSET FOR SYSMOD LU04743. DEFAULTS WERE USED.
GIM42001I    THE FOLLOWING CONDITIONS FOR SYSMOD LU04718 WERE NOT SATISFIED, BUT WERE IGNORED BECAUSE THE BYPASS OPERAND
              WAS SPECIFIED. PROCESSING CONTINUES.
GIM35966I    SYSTEM HOLD AO ORIGINATED BY SYSMOD LU04718 WAS BYPASSED.
GIM42001I    THE FOLLOWING CONDITIONS FOR SYSMOD RO94308 WERE NOT SATISFIED, BUT WERE IGNORED BECAUSE THE BYPASS OPERAND
              WAS SPECIFIED. PROCESSING CONTINUES.
GIM35966I    SYSTEM HOLD EXIT ORIGINATED BY SYSMOD RO94308 WAS BYPASSED.
GIM20501I    ACCEPT PROCESSING IS COMPLETE. THE HIGHEST RETURN CODE WAS 04.

Environment

Release : 12.0

Resolution

The above messages are SMP/E Warning messages and are indicating that SMP/E is passing its default link-edit parameters to the link-edit utility. This is acceptable and you can proceed with the actual ACCEPT of the maintenance.