Strange desired state of MNKNOWN when using the U (Unknown) command on panel 4.11.2
search cancel

Strange desired state of MNKNOWN when using the U (Unknown) command on panel 4.11.2

book

Article ID: 256532

calendar_today

Updated On:

Products

OPS/MVS Event Management & Automation

Issue/Introduction

When using the command "U" to set the current state of a resource to UNKNOWN, the state is being set to "MNKNOWN" instead of the correct "UNKNOWN"

Environment

Release : 14.0

Cause

The UNKNOWN state was incorrectly defined in the panel 4.11.1

Resolution

Change the unknown state to its correctly value of "UNKNOWN" in the OPSVIEW panel 4.11.1: