search cancel

Got ESP130W & ESP121E when running ESP batch JCL

book

Article ID: 255674

calendar_today

Updated On:

Products

ESP Workload Automation

Issue/Introduction

Our ESP batch JCL got warning and error messages below:

ESP130W UNABLE TO LOCATE ESP VECTOR TABLE
ESP121E ESP SUBSYSTEM NOT FOUND

Environment

Release : 12.0
Component: ESP Workload Automation

Resolution

Add job affinity card to make sure the JOB will run on the correct LPAR where the ESP system is running, like below:
/*JOBPARM SYSAFF=SYSB