Add UIM alarm filter attributes to spectrumgtw probe
search cancel

Add UIM alarm filter attributes to spectrumgtw probe

book

Article ID: 254983

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM) CA Unified Infrastructure Management On-Premise (Nimsoft / UIM) CA Unified Infrastructure Management SaaS (Nimsoft / UIM)

Issue/Introduction

We are using the spectrumgtw probe to integrate UIM and Spectrum. In the UIM alarm filter configuration, it is possible to filter which alarms to send to Spectrum. However, only five attributes can be selected.

Is it possible to add new attributes to this list,  for example "origin" information?

Environment

  • Release: UIM 20.4 CU5
  • spectrumgtw: 8.x
  • DX NetOps Spectrum 22.2.3.0.15

Cause

  • Guidance

Resolution

Yes, it is possible to add an additional attribute via Raw Configure -> Setup -> uimAlarmAttribute.

Once the parameter has been added, the new attribute can then be selected in the GUI:

This was tested and working as expected on UIM 20.4 CU5 connected to DX NetOps Spectrum 22.2.3.0.15.

Additional Information

spectrumgtw Advanced Configuration - Synchronize specific alarms