LS to MLS migration
Article ID: 254512
Updated On:
Products
Issue/Introduction
We have installed new LS server our new DC location and we are seeing he new LS in the existing MLS, all required port and host entry has been done but not showing LS in MLS,
All required port has been open as per the document
Environment
Release : 21.2
Cause
SELINUX enabled
Resolution
Disable SELINUX
Open the SELinux configuration file: /etc/selinux/config.
Locate the following line:
SELINUX=enforcing
Change the value to disabled:
SELINUX=disabled
Save your changes and close the file.
Reboot the server.
Login to oneclick administration page and check the landscapes.
Additional Information
https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/dx-netops/21-2/Fault-Monitoring-with-DX-Spectrum/administrating/distributed-spectroserver-administration/communication-across-firewalls/remote-spectroservers-and-firewalls.html
https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/spectrum/21-2/administrating/distributed-spectroserver-administration/communication-across-firewalls/spectroserver-and-oneclick-web-server-communication-across-firewalls.html
Attachments
Feedback
