Unable to restore RDF table from GLVBKP file

Products

• OPS/MVS Event Management & Automation

Issue/Introduction

We are unable to restore our RDF table from the GLVBKP file using the OPSVIEW panels. 

When we go to 7.6.3 panel to restore RDF table. it just gives below error message.

THE ALLOCATED SYSCHK1 WILL NOT BE USED BECAUSE YOUR MAX TEST GLOBALS IS TOO SMALL

 

 

 

 

Environment

Release : 14.0

Resolution

I was able to recreate the error you are getting by lowering the value of the parameter "Max Test Globals" in the OPSVIEW panel 0.1. The default value for this parameter is the value of the OPS parameter GLOBALMAX. Please, check the value of GLOBALMAX in the panel 4.1.1 and then go to the panel 0.1 and set "Max Test Globals" to a number a little higher than GLOBALMAX. If the problem persists, increase the value again until you find a value that solves the problem.