DCPROFILE does not show any numbered exits
Article ID: 252390
Updated On:
Products
IDMS
Issue/Introduction
LOOK PROGRAM=RHDCUXIT finds the module but DCPROFIL doesn't list any numbered exit.
Would it then be the base RHDCUXIT that is done in JOB 3 of the BASE install ?
Environment
Release : 19.0
Resolution
The Answer is YES
We do not deliver an RHDCUXIT load module.
It is created in JOB03 from the source in CUSTOM.SRCLIB(RHDCUXIT) and that source defines no exits, so if you need to define any of your own numbered exits you would need to put the correct source in CUSTOM.SRCLIB(RHDCUXIT) before running the assembly/link.
Additional Information
Feedback
Yes
No
Powered by
