Endevor error message "C1G0012W A PROCESSOR GROUP NAME CHANGE OCCURRED." on Element Move action

Products

• Endevor

Issue/Introduction

A Element had it's processor group name changed when added/updated/edited.

When the element is moved a message like this will be received:(the group name was changed from oldgroup)

C1G0012W  A PROCESSOR GROUP NAME CHANGE OCCURRED. EXECUTING THE DELETE PROCESSOR FROM GROUP oldgroup 
C1G0143I  BEGINNING EXECUTION OF DELETE PROCESSOR CONDELE OF GROUP old group.  

The delete processor from the old processor group will be run.                      

 

 

 

 

Environment

Release : all

Cause

This was caused by the change in the processor group name.

Resolution

No action is required in most cases. The delete processor running is desired or causes no harm.

If you do not wish to issue the delete you can change the delete processor name in the old processor group to *NOPROC*. So no delete processing will be done for this processor group. You can change the delete processor in the old processor group back to the original name once the action is complete.