Notification Manager link from MTCA still uses default port of 8080

Products

• Automation Point

Issue/Introduction

Automation Point 11.7.1.0 BETA Rev=UnofficialBuild  Jun 13 2022

When selecting the NOTIFICATION MANAGER selection from the tabbed window, it uses port 8080 instead of what we have defined in Configuration Manager (8081).

 

Environment

Release : 11.7

Resolution

The LOCAL stays intact in order to preserve it.   So in order to change the port, rather than going through the Notification Manager, go into the Alert Manager control panel and make the address change there and specify as a Remote.