Can commands in CAUTOCMD be triggered without an IPL?
Article ID: 250579
Updated On:
Products
CA 1 Flexible Storage
Issue/Introduction
Is it possible to trigger the CAUTOCMD without an IPL in order to test if the 'S TMSINIT ' after a CAS9 execution ?
Can this be tested without an IPL?
Environment
Release : 14.0
Component : CA 1 Tape Management
Resolution
The AUTOCMDS member is only read and executed on the 1st execution by design. You can force it to be executed by passing the AUTOCMDS parameter on the start command as follows: S CAS9,,,AUTOCMDS
Feedback
Yes
No
Powered by
