Upgrading CICS TS5.4 to CICSTS 5.6 and do not see the ACF2 phase messages after CA-ENF INSTALLING THE CICS INTERFACE + DFHKE0201

Products

• ACF2 - z/OS

Issue/Introduction

I am upgrading the CICS TS 5.4 to CICSTS 5.6.

I have installed CA-Common Services 15.0

When CICS starts, I do no see the ACF2 Phase message after the "CA-ENF Installing the CICS interface" message as I did with CICSTS 5.4.

CICS then abends.

 +DFHXS0206 - CA-ENF INSTALLING THE CICS INTERFACE           
 +DFHKE0201 CIC1     ABOUT TO TAKE SDUMP. DUMPCODE: KERNDUMP,DUMPID: 0/0000. (MODULE        DFHKESTX). 

The CICSREL parameter in ENFPARM has been updated for CICSTS 5.6

 MODE(CICS,ON)         
 CICSREL(65,67,71,73)  

Environment

Release : 16.0

Component : CAIENF

Resolution

+DFHXS0206 - CA-ENF INSTALLING THE CICS INTERFACE           
 +DFHKE0201 CIC1     ABOUT TO TAKE SDUMP. DUMPCODE: KERNDUMP,DUMPID: 0/0000. (MODULE        DFHKESTX)

Dump showed that an incorrect version of CAKSACFI was being used.
For CTS 5.6 the CAKSACFI version must be at least SO09833