Install error when trying to install CABI

Products

• DX NetOps

Issue/Introduction

We are getting the following error when trying to install CABI On Linux:

[root@CABI]# ./setup.sh

Preparing to install

Extracting the JRE from the installer archive...

Unpacking the JRE...

Extracting the installation resources from the installer archive...

Configuring the installer for this system's environment...

 

Launching installer...

Graphical installers are not supported by the VM. The console mode will be used instead...

=======================================================

 

Installer User Interface Mode Not Supported

 

The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The valid UI modes identifiers are GUI, Console, and Silent

Environment

Release : CABI

Component : Jaspersoft for CA Spectrum

Cause

DISPLAY environment variable not configured properly.

Resolution

You must run an Xterm on the client system and configure the DISPLAY environment variable on the Linux system correctly.