Configuration required to receive all messages from CA7 and Autosys

Products

• Automation Point

Issue/Introduction

We have Autosys and CA7 going to Automation Point.  I want to know is Automation Point receiving all of the error messages from CA7 and Autosys?  How can I see the total messages from CA7 and Autosys?  What configuration should I change if I want all of the error messages from CA7 and Autosys? 

 

Environment

Release : 11.7

Component : Automation Point

Resolution

Automation Point has no control over which messages are sent to any of its defined console sessions because it is only a receiver. The application owning the console that Automation Point is monitoring has full control over which messages are directed to its console. There is no configuration within Automation Point which controls this.