Runtime option display changed from XREF() to XREF(ACTIVE)

Products

• JCLCheck Workload Automation

Issue/Introduction

Before JCLCheck maintenance:

                    
OPTS     PARAMETERS: LIST CCLIST FULLLIST XREF PXREF RPTRPT ERROR SXREF         
OPTIONS IN EFFECT: CSI CTLSCAN() ERROR(END) HCD OPTIONS(OPTS) REPORT RPTRPT CCLIST(5) FULLLIST JOB JOBSEV 
                     LIST(SYSPRINT) PXREF(RPT) SXREF(ACTIVE) XREF()             

After JCLCheck maintenance: 

                     
OPTS     PARAMETERS: LIST CCLIST FULLLIST XREF PXREF RPTRPT ERROR SXREF         
OPTIONS IN EFFECT: CSI CTLSCAN() ERROR(END) HCD OPTIONS(OPTS) REPORT RPTRPT CCLIST(5) FULLLIST JOB JOBSEV 
                     LIST(SYSPRINT) PXREF(RPT) SXREF(ACTIVE) XREF(ACTIVE) 

 

 

 

Environment

Release : 12.0

Component : JCLCheck Workload Automation

Resolution

PTF SO09361 changed how runtime option XREF is displayed on the list of "Options in Effect". 

Prior to SO09361, XREF has one sub-option and that is NOMEM.  If XREF(NOMEM) is set, the option is displayed as XREF(NOMEM).  If XREF is used alone, the option is displayed as XREF().

PTF SO09361 introduced another sub-option for XREF, and that is SORT.  Now XREF(ACTIVE) will always display unless NOXREF is used.  In other words:

- use XREF, Options in Effect show XREF(ACTIVE)

- use XREF(NOMEM), Options in Effect show XREF(ACTIVE)

- use XREF(SORT), Options in Effect show XREF(ACTIVE) 

- use XREF(NOMEM,SORT), Options in Effect show XREF(ACTIVE)