Jaspersoft report cannot be executed
book
Article ID: 247735
calendar_today
Updated On: 11-01-2023
Products
Clarity PPM On Premise
Clarity PPM SaaS
Issue/Introduction
It is not possible to execute a specific report. It shows an error pop-up with the following message. This happens only for a specific user.
Error filling report argument
Cause
Saved parameters / filters that refer to values that are no longer available in the DWH DB.
Resolution
- Run the report by not choosing a saved filter
- If it executes properly, then use the values that are available now, to save a new filter.
Feedback
Was this article helpful?
thumb_up
Yes
thumb_down
No