SDM not seeing traps from SDMConnector

Products

• CA Spectrum
• DX NetOps

Issue/Introduction

Secure Domain Connector installed in customer's secure zone. I can model a device using the SDC but I am not seeing any traps.

 

Environment

Release : 21.2

Component : Spectrum Core / SpectroSERVER

Cause

The snmp_trap_ip was configured incorrectly in the $SDMConnector/bin/sdc.rc file. 

Resolution

Set the following parameters to the IP address of the SDMConnetor and restart the SDMConnector process. 

icmp_listen_ip= ---> change to SDC ip address
snmp_comm_ip=----> change to SDC ip address
snmp_trap_ip=---> change to SDC ip address