Can the current value of WARNPTCT be displayed using a command?
search cancel

Can the current value of WARNPTCT be displayed using a command?

book

Article ID: 245435

calendar_today

Updated On:

Products

Jobtrac

Issue/Introduction


Is there any command to display the current value of WARNPCT?    We are getting the following message: "TRACWARN - DB Area Near Full: 0161        7%" .  It  appears to be alerting at very low levels.


Environment

Release : 11.0

Component :

Resolution

There is not a  display command to show the current WARNPCT.   The only time the value for this shows is when command  F JOBTRACx,WARNPCT=nn is issued to change the value.  When the command is issued you will see the following messages in the Jobtrac log

TRAC1061I Command received: WARNPCT=85           
TRACINFO - JOBTRAC7 WILL NOW WARN ABOVE  85%.    
TRAC1068I WARNPCT=85 command processing complete