Release level not showing on panel OPPRIMOP (OPS/MVS Primary panel)
Article ID: 245026
Updated On:
Products
Issue/Introduction
Everything with OPSMVS is working fine but when the Primary Menu panel shows a blank release level.
TSO isrddn is showing all correct files are properly allocated.
OPPRIMOP S ------ MVS1 --- OPSVIEW Primary Options Menu ----- Subsystem OPSS
Option ===>
0 Parms Set OPSVIEW and ISPF default values User ID - USER1
1 OPSLOG Browse OPSLOG Time - 12:24
2 Editors AOF Rules, REXX programs, SQL Tables Level -
3 Sys Cntl Display/Modify System Resources
4 Control Control CA OPS/MVS
5 Support Support information
6 Command Enter JES2/MVS/IMS/VM commands directly
7 Utilities Run CA OPS/MVS Utilities
I ISPF Use ISPF/PDF services
S SYSVIEW CA SYSVIEW Performance Management
T Tutorial Display information about OPSVIEW
U User User-defined applications
X Exit Exit OPSVIEW
CA OPS/MVS Event Management and Automation
Copyright . Broadcom. All rights reserved.
Press END or enter X to terminate OPSVIEW
Environment
Release : 14.0
Component : OPS/MVS
Cause
A mismatch of release levels libraries between the ISPF and OPSMAIN environment
Resolution
The LEVEL information on the Primary OPS/MVS menu (OPPRIMOP) wasnt displayed because the OPSMAIN stc was picking up some old release load modules..
It was showing rel 13.00.00 in the OPS3253I and OPS3267I messages:
OPS3253I CA OPS/MVS JES2 Release 13.00.00 subsys OPSS initialization complete
OPS0075I EPI TERMINAL COMMAND PROCESSING STARTED
OPS3267I CA OPS/MVS Event Management and Automation r13.0. Copyright (C) 201
After changing the CCLXLOAD to the correct, rel 14.0 version load libraries in the OPSMAIN STEPLIB, or LINKLIST, it was showing the proper 14.0.xx release in the Primary menu.
Feedback
