Install Cleanup on LPARS that switch from RACF to Top Secret

Products

• Cleanup

Issue/Introduction

4 LPARS are shared with one database.  2 LPARs can be switched between RACF and TSS at IPL and the other 2 are strickly RACF and Top Secret.

How can Cleanup be installed?  Would system symbolics  be used?

Environment

Release : 12.1

Component : Cleanup for Top Secret

Resolution

Only one 'install image" (SMP) is required, then each LPAR can run off of those LOADLIBs. However, the STC (JCL) that gets STARTed must correspond to the correct ESM that is running.  Using some symbolic to indicate which STC to START, or which STC JCL to use, would be the simplest.