Updating TPX messages

Products

• TPX - Session Management

Issue/Introduction

TPX comes with default messages. In case it is required to have a personalized message, follow the procedure described below:

Resolution

The desired result can be achieved (adding a personalized message) by modifying the TPX messages.

Note that One-line messages are located in CB0VPENU(TxxMSGL), where xx is the language code.

One-line messages (marked in RED) can be modified, but the message prefix and number (Marked in BLUE) must remain the same.

Example:
IENS004A PASSWORD/PASSWORD PHRASE OMITTED OR IS NOT CORRECT.
IENS004B TRY AGAIN OR HIT 'CLEAR' TO CANCEL.               
 
After modifying the messages, restart CA TPX to put the changes into effect.

NOTE:

Apply the following PTFs to enable TxxMSGL changes to take effect after reload without the need to cycle the TPX started task:

• R086392 - TPX NEEDS TO BE RECYCLE TO ACTIVATE TENMSGL UPDATES
• R086684 - TPX NEEDS TO BE RECYCLE TO ACTIVATE TENMSGL UPDATES

The information above can be found at: Modify One-Line Messages