search cancel

Can you configure a wait between restarts triggered by the n_retrys attribute when a job fails?

book

Article ID: 242408

calendar_today

Updated On:

Products

CA Workload Automation AE

Issue/Introduction

Is there a way to configure a job to where it will wait a certain amount of time between each restart that is triggered by the n_retrys attribute when the job fails?

Environment

Release : 12.0

Component : CA Workload Automation AE (AutoSys)

Resolution

There is no control for the interval between the retries triggered by the n_retrys attribute when a job fails. They all occur immediately after each other until the configured amount of retries are exhausted.