ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Where is OI OPSTART2 command coming from during startup?

book

Article ID: 241685

calendar_today

Updated On:

Products

OPS/MVS Event Management & Automation

Issue/Introduction

I have one more small issue with V14 I think… In the middle of the start of OPSOSF I see an ‘OI OPSTART2’  I can’t figure out where it is coming from…

Please advise.

Environment

Release : 14.0

Component : OPS/MVS

Resolution

OI OPSTART2 is the default value for the BEGINCMD parameter.

Go to the parameter screen (=4.1.1) and set the Name field to BEGIN.  On the resulting screen you should see there that the value of BEGINCMD is 'OI OPSTART2'.

We provide a sample of OPSTART2 in the **.CCLXSAMP library, which can be modified.

More information on the BEGINCMD parameter can be found in the OSF Parameters section of the Reference Manual.  

Additional Information

For release 14.0 please see:  https://techdocs.broadcom.com/us/en/ca-mainframe-software/automation/ca-ops-mvs-event-management-and-automation/14-0/reference/parameter-reference/parameters-for-facilities/osf-parameters.html#concept.dita_170ffc54c774cb78ecb1e992b38e6afbec696df8_BEGINCMDParameter