ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Custom certification using all scalar OIDs which creates components shows as supported but creates no components.
Article ID: 240254
Updated On:
Products
CA Performance Management - Usage and Administration
Issue/Introduction
Custom certification usig all scalar OIDs which creates components shows as supported but creates no components.
There are no filters in the Vendor Certification.
The Vendor Certification uses all scalar OIDs
Cause
When creating components, an index must be used in the Vendor certification even when all OIDs are scalar.
Environment
Release : 21.2
Component : DX Netops Performance Management Certifications
Resolution
If components are used, then an index must be configured in the Vendor Certification.
As all the OIDs are scalar the following can be used in the ExpressionGroup
<Expression destAttr="Indexes">0</Expression>
Feedback
Yes
No
Powered by
