search cancel

Setting Variables/Metrics to send Time Series Data to MOI

book

Article ID: 240221

calendar_today

Updated On:

Products

SYSVIEW Performance Management

Issue/Introduction

MOI only processes Time Series Data (TSD) sent to it from SYSVIEW. 

The variables/metrics must be marked as TSD in SYSVIEW.  

The Resolution section below contains instructions on how to change a variable/metric in SYSVIEW so that it can either be sent or not sent to MOI. 

 

Environment

Release : 16.0

Component : SYSVIEW

Resolution

 
To review what CICS variables/metrics are being sent to MOI as TSD data by executing the following SYSVIEW command:
 
            LIBVIEW PARMLIB CICSDATA
 
SYSVIEW does not automatically send CICS variables/metrics out of the box.   You have to specify what you want to send to MOI. 
 
To set a variable/metric to TSD, edit SYSVIEW PARMLIB member CICSDATA or edit SYSVIEW SITELIB member SVWYVARS and add the following line for each variable/metric that you
would like to be sent to MOI:
 
           VARIABLE-SET      CICS:STGVIOLS:TSD
 
After adding the TSD line in SYSVIEW PARMLIB member CICSDATA or SYSVIEW SITELIB member SVWYVARS if you are using SITELIB , stop and then start SYSVIEW in any or all CICS regions that you want the metric collected in.   
 
Go back to the SYSVIEW CVARS display to verify the TSD column now says TSD for the variables set to TSD. You should see the metrics flowing to MOI after data collection runs in SYSVIEW.