ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Telnet check via netconnect probe - adding port

book

Article ID: 239962

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

I am trying to configure telnet session using net_connect probe. But  I can not give destination ipaddress to initiate telnet . Can you please guide .

 

 

Environment

Release : 20.3

Component : UIM NET CONNECT

Resolution

Please go to setup-> Advanced tab, highlight telnet, and edit. Now you can change the port. Here is the screenshot for reference

https://api-broadcom-ca.wolkenservicedesk.com/attachment/get_attachment_content?uniqueFileId=MDcbnQvganyzWkjNANQRdQ==