ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
PM is not discovering all of the RPM tests configured in the juniper routers
Article ID: 239604
Updated On:
Products
CA Performance Management - Usage and Administration
DX NetOps
Issue/Introduction
CA PM is not discovering all of the RPM tests configured in the juniper routers
Environment
Release : 21.2
Component :
Resolution
In this case the customer had set up a ping timestamp test on the Juniper router and it was not getting discovered. Customer set up a UDP pin and ICMP ping test and those were discovered correctly and provided the jitter statistics they needed.
Feedback
Yes
No
Powered by
