ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

oracle probe - remote monitoring

book

Article ID: 239157

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction


We installed oracle probe on a secondary hub "cauimhub4v" to remote monitoring oracle server "ServerDB"
in operator console  I can't view alarms and QOS metrics under ServerDB device  , but they are found under secondary hub "cauimhub4v"


 

Environment

Release : 20.3

Component : UIM - ORACLE

Resolution

In the .cfg files if you see the configuration
alarm_source = 
      group = 
      set_alarm_source_as_qos_source = 0

You need to set the alarm source to the dbserver, and then   set_alarm_source_as_qos_source=1

Alarm Source
: overrides the source name of the alarm on the Unified Service Management. If you do not specify a value, robot IP address is used.
Then you also need to select Use Alarm Source As QoS Source. This specifies the probe to use the Alarm Source
 value as the QoS Source.
Powered by Wolken Software