After changing the name of a Container model (LAN or Network for example), the TopologyModelNameString attribute id 0x129e7 reflects the proper value but the Command Line Interface(CLI) does not show the proper value. It still shows the old value.
For example:
- I created a LAN Container in the Universe named "LAN A".
- I created a device model within the "LAN A" Container.
- Both OneClick and CLI show the value of the TopologyModelNameString attribute id 0x129e7 for the device model as "Universe:LAN A"
- I changed the name of the "LAN A" Container to "LAN B"
- OneClick shows the value of the TopologyModelNameString attribute id 0x129e7 for the device model as "Universe:LAN B" which is correct:
- However, CLI shows the value of the TopologyModelNameString attribute id 0x129e7 for the device model as "Universe:LAN A" which is incorrect:
./show attributes attr=0x129e7 mh=0x1000071
Id Name Iid Value
0x129e7 TopologyModelNameString Universe:LAN A
Release : 21.2.X
Component : Spectrum Applications
The solution to this issue will be provided in the next Spectrum release after the release of 21.2.10.
No projected release dates for Spectrum 21.2.10 or the following Spectrum version at the time this knowledge article was published.