ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Test Case count keeps changing for All Pairs, All Edges, All In/Out Edges

book

Article ID: 238621

calendar_today

Updated On:

Products

CA Agile Requirements Designer

Issue/Introduction

Test Case count keeps changing each time while trying to generate from path explorer. 

For eg. If selecting All Pairs, and generating, once it gives 163, if i'll repeat the steps again it will change to 166 and so on.

Cause

This is expected behavior

Environment

ARD 3.2.X

Agile Requirements Designer sutdio

Resolution

Below is an update from our dev team.

Comment:
Test case count will change between runs since we are using the non-deterministic algorithm.
However, it is worth saying that there were improvements in ARD 3.2.5 so it will not vary as much as in 3.2 (with the latest optimizer)

https://techdocs.broadcom.com/us/en/ca-enterprise-software/devops/agile-requirements-designer/3-2/release-notes.html