Command to DISPLAY EVENT MODE
search cancel

Command to DISPLAY EVENT MODE

book

Article ID: 237878

calendar_today

Updated On:

Products

CA 7 Workload Automation

Issue/Introduction

Is there is a command within CA 7 that will identify ENF versus Logger is being used for IDASH?

Environment

Release : 12.1

Component : CA 7

Resolution

The command is:

/DISPLAY,ST=EVENTS                                                              
                                                                               
 *** WORKLOAD EVENTS ***                                               PAGE 0001
                                                                               
  *NAME*  *L2ENFT* F1 F2 F3 F4  *EVWA*  *EVLGWA*                                
                                                                               
 CA7BRWSE 3B600C58 04 00 00 00 00000000 00000000 CREATE=Y ENF=Y LGR=N ENFQ=N    
                                                                               
 L2JOBCMP 3B600CA8 04 00 00 00 00000000 00000000 CREATE=Y ENF=Y LGR=N ENFQ=N    
                                                                               
 CAXPSFBK 3B600CF8 04 00 00 00 00000000 00000000 CREATE=Y ENF=Y LGR=N ENFQ=N    
                                                                               
 CA7LOG   3B600D48 28 00 00 00 3C6093F8 3C60A000 CREATE=Y ENF=N LGR=Y ENFQ=Y    

In the above display, the name is CALOG.  This information is also shown in the CA 7 INIT file on the EVENT statement.
                                                                               

Additional Information

https://techdocs.broadcom.com/us/en/ca-mainframe-software/automation/ca-workload-automation-ca-7-edition/12-1/configuring/programming/manage-the-initialization-file/event-statement.html