ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Unable to get wasp probe to pull a database connection

book

Article ID: 237605

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

We had setup a new wasp configuration on a system and it was not able to connect to the database engine and pull the string. This will cause the wasp probe to go into a maximum restarts state.

Environment

Release : 20.3

Component : wasp

Resolution

We found that the volume where UIM was installed on on the primary hub server had filled up. For this reason we were unable to make a connections to the data_engine and get the connection string. After clearing space on the primary we were able to establish the connection to the data_engine.