ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Physical Node Power Supply Warning PAM-CMN-2007

book

Article ID: 237586

calendar_today

Updated On:

Products

CA Privileged Access Manager (PAM)

Issue/Introduction

Cause

N/A

Environment

Release : All

Component : Any PAM hardware appliance

Resolution

Steps to perform: 

  1. Turn OFF the PAM appliance
  2. Reseat the far right PSU 
  3. Turn ON the appliance and test.
  4. If the same issue persist turn OFF the appliance and remove the PSU/s 
  5. Swap PSU/s and test
  6. If the replaced PSU shows bad we have to replace it. 

Attachments

Powered by Wolken Software