ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

How to setup OI Connector metrics on dashboard?

book

Article ID: 237497

calendar_today

Updated On:

Products

DX Operational Intelligence

Issue/Introduction

Getting the IO Connector metrics in OI performance analytics. These metrics are coming from the CA Performance Management (CAPM). We need the metric with hostname and IP of the device. How to setup a dashboard for these metrics?

Environment

Release : 21.3

Component : DX Dashboards

Resolution

BuilD Dx Dash board with following settings.

Source Name Specifier

Specifier:REGEX

Pattern: NetOps\|CAPM\|.*\|.*

Attribute Name Specifier

Specifier:REGEX

Pattern: .*\:activeSessionUsers

Under Attribute Name Specifier you will see "Aggregation" and "Additional Filters"

expand "Additional Filters" under "Series Name" select "Metric | Custom Attribute".

Add two values.

host and ip

Make sure to add in a separate box.

This will show the metric with hostname and IP of the device for activeSessionUsers metric.

Powered by Wolken Software